A site investigation collects the information a contaminated land risk assessment needs. A competent person you appoint carries it out and reports. Those who may rely on the report include the local planning authority and the local authority under Part 2A of the Environmental Protection Act 1990. They also include the Environment Agency, and a buyer, lender or insurer.
Work out what is driving the investigation
The trigger decides who sets the scope, who reviews the report and which question the report answers. The Environment Agency says its land contamination guidance can be used for voluntary remediation, planning, assessing liabilities or Part 2A. It can also be used for the purchase, transfer or sale of land, funding decisions, valuation or insurance.
| Trigger | Who sets what is needed | Question the investigation answers |
|---|---|---|
| Planning application or planning condition | The local planning authority, applying the National Planning Policy Framework and planning practice guidance | Whether the site is suitable for the proposed use, taking account of ground conditions and how far risks can be mitigated |
| Part 2A inspection by the local authority | The local authority. Defra's statutory guidance says that where the land is likely to meet a special site description, the authority should consult the Environment Agency and, subject to the Agency's advice and agreement, arrange for the Agency to carry out any intrusive inspection | Whether the land is contaminated land for its current use |
| Voluntary work or a transaction | You, and the buyer, lender or insurer where one is involved. The regulator, where its approval or agreement is needed | Whether the land carries an unacceptable risk and what is known about it |
Planning
The National Planning Policy Framework (NPPF), published on 17 August 2026, sets planning policy for decisions in England. Its ground conditions policy, P2 in Chapter 17, says sites should be suitable for their proposed use. That means taking into account ground conditions, including risks from contamination. It also means taking into account the extent to which those risks can be mitigated and the potential impacts on the natural environment of remediation. The policy says adequate site assessment information, prepared by a competent person, should be available to inform that consideration. Annex C lists site assessment information, prepared by a competent person, as the information requirement for P2 where that policy applies.
The NPPF says that where contamination affects a site, responsibility for securing a safe development rests with the developer and/or landowner. It also says remediated land should, as a minimum, not be capable of being determined as contaminated land under Part 2A.
Planning practice guidance says applicants should provide proportionate but sufficient site investigation information if there is reason to believe contamination could be an issue. A competent person should prepare it. The guidance says the first stage may require at least a desk study and site walk-over report. It says further site investigation and risk assessment will be needed before the application can be determined. The exception is where that initial assessment clearly shows the risk can be reduced to an acceptable level.
For an outline application, the guidance says the authority needs to be satisfied, among other matters, before it grants permission that:
- it understands the contaminated condition of the site
- the development is an appropriate way of remediating it
- it has enough information to be confident of granting full permission later, bearing in mind the need for the necessary remediation to be viable and practicable
The NPPF says conditions that must be discharged before development commences should be avoided unless there is a clear justification.
The guidance also says site investigation activities, including field trials, may need planning permission if they are not part of a development, and in some cases may also need environmental permits.
Part 2A
Land is contaminated land under Part 2A only if it appears to the local authority in whose area it sits to be in a condition, by reason of substances in, on or under the land, in which either of these applies:
- significant harm is being caused or there is a significant possibility of such harm
- significant pollution of controlled waters is being caused or there is a significant possibility of it
For Part 2A, controlled waters has its Water Resources Act 1991 meaning: relevant territorial waters, coastal waters, inland freshwaters and groundwater. Water in underground strata above the saturation zone is not included. The authority must act in accordance with the Secretary of State's statutory guidance in deciding this. A consultant's report, including one you commission, does not itself make land contaminated land.
Every local authority must cause its area to be inspected from time to time to identify contaminated land.
In Part 2A, remediation includes doing anything to assess the condition of the contaminated land, adjoining or adjacent land or affected controlled waters. It also includes works to prevent or remedy harm and later monitoring inspections. Investigating contaminated land is itself remediation in that sense.
Defra's statutory guidance says that under Part 2A risks should be considered only in relation to the current use of the land. That includes reasonably likely future uses that would not need a new or amended grant of planning permission. A Part 2A assessment and a planning assessment ask different questions.
Voluntary work
Once land has been identified as contaminated land or designated a special site, the enforcing authority must not serve a remediation notice on a person if and so long as it is satisfied that appropriate things are being, or will be, done by way of remediation without a notice. The responsible person must then prepare and publish a remediation statement. That is the person who is doing or has done those things, or who the authority is satisfied will do them. The statement records what is being, has been or is expected to be done, by whom and within what periods.
Offering information to the authority
Defra's statutory guidance says the authority should consult the landowner before inspecting the land, unless there is a particular reason it cannot. It says the authority should not use statutory powers of entry to carry out intrusive investigations, including taking sub-surface samples, if either of these applies:
- it has already been given appropriate, detailed information on the condition of the land, enough for it to decide whether the land is contaminated land
- a relevant person, such as the owner or a person who may be liable for the contamination, offers to provide that information within a reasonable and specified time and then provides it within that time
Special sites
For a special site the enforcing authority is the Environment Agency, not the local authority. Contaminated land must be designated a special site in the cases the Contaminated Land (England) Regulations 2006 prescribe. They include land affecting controlled waters in set circumstances, such as water used for drinking water supply that then needs a treatment process. They also include land on which petroleum refining or explosives manufacture has been carried on at any time.
Appoint a competent person
The NPPF defines a competent person to prepare site assessment information as a person with all of these:
- a recognised relevant qualification
- sufficient experience in dealing with the type of pollution
- membership of a relevant professional organisation
The Environment Agency says that for England you must use and meet the NPPF definition. It expects the person applying its land contamination guidance (LCRM) to be appropriately competent in the tasks they carry out at each stage.
LCRM says the National Quality Mark Scheme (NQMS) is voluntary. If you decide to use it, a registered Suitably Qualified Person quality-checks your reports. You still need the regulator to review them, and you pay a small administration fee.
Defra's statutory guidance says the authority first looks for persons who caused or knowingly permitted each significant contaminant linkage, whom it calls Class A persons. A contaminant linkage is the relationship between a contaminant, a pathway and a receptor. A significant one gives rise to a level of risk sufficient to justify determining the land as contaminated land. The persons responsible for a linkage make up its liability group.
The guidance says the authority should exclude any person who is in a Class A liability group solely by reason of providing advice or services for assessing the condition of land. For a consultant who carries out an intrusive investigation, the exclusion applies except where both of these are true:
- the investigation is itself a cause of the existence, nature or continuance of the significant contaminant linkage in question
- the client is not a member of the liability group
The guidance says an exclusion applies only to the linkage in question. It says no exclusion test should be applied if it would exclude every remaining member of the liability group.
Keep the investigation in the right order
The Environment Agency expects you to follow LCRM when managing the risks from historic land contamination. It says you must always check with the local authority and other regulators that using LCRM is acceptable, and that they may give additional guidance. LCRM advises consulting the regulator before the investigation where the site is complex. It gives the same advice where piling or penetrative ground improvement is proposed. The aim is to find out if there are any specific regulatory or reporting requirements. For piling or penetrative ground improvement, LCRM says you must contact the regulator.
The first LCRM stage is risk assessment, which works through preliminary, generic quantitative and detailed quantitative tiers. Options appraisal, then remediation and verification, follow where the risks are unacceptable. Intrusive site investigation belongs to the first stage.
The Environment Agency says you must always start with a preliminary risk assessment. It says risk assessment is iterative. You can work through the tiers in order or move from the preliminary to the detailed quantitative tier. As part of a generic or detailed quantitative risk assessment you collect detailed site information, usually through an intrusive site investigation. If you go straight to options appraisal, LCRM says you still need that investigation information.
For an intrusive site investigation, LCRM says you can use a phased approach such as the one in table 1 of BS 10175:
- a preliminary investigation, which can include an exploratory investigation
- a detailed investigation
- a supplementary investigation
The NPPF glossary says risk assessments of land potentially affected by contamination should be carried out in accordance with established procedures, such as BS 10175. LCRM says to include in a field investigation report which part of LCRM it relates to and which phase, stage or zone of investigation it relates to.
Control health and safety on site
Under the Construction (Design and Management) Regulations 2015 (CDM 2015), construction work includes the preparation for an intended structure. That covers site clearance, exploration, investigation (but not site survey) and excavation (but not pre-construction archaeological investigations). A client is any person for whom a project is carried out.
Where the project includes, or is intended to include, construction work, a client must make suitable arrangements for managing the project, including allocating sufficient time and other resources. The client must also provide pre-construction information as soon as is practicable to every designer and contractor appointed, or being considered for appointment, to the project.
LCRM says you must assess whether the site may contain or have been affected by unexploded ordnance before the site walkover and intrusive investigation, starting with a preliminary unexploded ordnance risk assessment. It says you must consider health and safety issues before the walkover.
Check the testing and screening standards LCRM sets
For chemical testing of soils on sites the Environment Agency regulates, LCRM says the results you submit must meet MCERTS. LCRM says you must also check that the laboratory has MCERTS accreditation for all the parameters you need. If MCERTS is not available or does not apply to a contaminant, LCRM says to contact the regulator.
For sites the Environment Agency regulates, LCRM says it will accept results from a rapid measurement technique without further laboratory testing if the technique has MCERTS accreditation. Otherwise you need to meet the rapid measurement techniques protocol, and agree with the Environment Agency what proportion of results needs MCERTS laboratory analysis.
In England, LCRM says you must use the category 4 screening level, not the soil guideline value, for human health risk assessment. That applies where both exist for the same contaminant. It says the Environment Agency is not publishing new soil guideline values.
Agree what the reports contain
LCRM says a preliminary risk assessment report should include:
- site details and objectives
- details of the desk study and site walkover
- an unexploded ordnance assessment
- the contaminant linkages and the conceptual site model
- qualitative risk screening
- uncertainties and data gaps
- conclusions with next steps
LCRM says the field investigation report is factual information and should include:
- the objectives and strategy
- who commissioned the investigation
- the results and the uncertainties
- the sampling and monitoring locations
- borehole and trial pit logs
- laboratory certificates, showing MCERTS where it applies
LCRM says to keep factual and interpretative information separate.
Tell the right people
Planning practice guidance says early engagement with the local planning and environmental health departments clarifies what assessment is needed. It says the Environment Agency will have an interest in special sites. It will also have an interest in all sites where there is a risk of pollution to controlled waters.
LCRM says that if you suspect radioactive contamination in England you must contact your local authority.
LCRM says you must report an incident immediately if polluting substances have entered, or could enter, a watercourse or soak into the ground. For England, LCRM points to the service for reporting an environmental incident.
Environment Agency voluntary advice
The Environment Agency offers a voluntary remediation advice service. It is advisory only, and the developer or landowner remains responsible for making sure a contaminated site is safe to develop and occupy. The service is restricted to sites where contamination has affected controlled waters. You can use it if your site:
- sits outside any planning application or discharge of condition consultation
- is not regulated under environmental permitting
- is not subject to a Part 2A determination, an environmental damage remediation notice or an anti-pollution works notice
The Environment Agency expects you to be a competent person. It can review documents prepared using LCRM, including site investigation proposals and results. The service is charged. An interim fee for 5 hours of work plus VAT must be paid before work starts, with monthly invoices after. It may not always be available, depending on local resources. Contact the area groundwater and contaminated land team first. There is no appeal against the advice.
Get voluntary remediation advice for contaminated land and groundwater (opens in a new tab)
Agree the report and the next decision
LCRM says that if you conclude the risks are acceptable, you can end the process with the regulator's agreement. It says that if there are unacceptable risks, remediation or mitigation is required and options appraisal and remediation follow in order.
LCRM also says the decision on what to do at the end of a tier may need approval or agreement from the regulator. Examples are meeting a Part 2A obligation or satisfying a planning condition.
Legal basis
Primary legislation and key regulations
Official guidance
Land contamination technical guidance (GOV.UK) (opens in a new tab)
Environment Agency · England
National Planning Policy Framework (NPPF) (opens in a new tab)
MHCLG · England
Contaminated Land Statutory Guidance (DEFRA 2012) (opens in a new tab)
Publication · DEFRA
Land Contamination Risk Management (LCRM) (opens in a new tab)
Publication · Environment Agency
Environment Agency guidance on land affected by contamination (opens in a new tab)
MHCLG · England and Wales